Datatek IPv6 Transformer User Manual - Manual (Page 60)

S E C T I O N 8 W E B G U I S Y S T E M
60
Figure 27. Manual IPsec : Security Policy Edit Screen continued
Disable
This box is checked to disable the SP without deleting all its parameters from the configuration
database.
Source IP
This is the source IP address of the SP. This field is comprised of an IP address and a port
number. The IP address is matched against the source address in the IP header and the port
number is matched against the port number in the higher layer protocol header. Leave the port
field blank to allow any port number if the higher layer protocol does not support port numbers.
The type of address may be a single host or a network address. For a single host IPv6 address all
128 bits of the address are matched and for an IPv4 address, all 32 bits of the address are
matched. A typical single host may be the IPv6 address of a legacy IPv4 host. For a network