Datatek IPv6 Transformer User Manual - Manual (Page 65)

S E C T I O N 8 W E B G U I S Y S T E M
65
Disable
This box is checked to disable the SA without deleting all its parameters from the configuration
database.
Source IP
This is the source IP address of the SA. The IP address is matched against the source address in
the IP header.
Destination IP
This is the destination IP address of the SA. The IP address is matched against the destination
address in the IP header. The destination IP address, in conjunction with the Security Parameter
Index and the IPsec protocol, uniquely identify the SA.
IPsec Protocol
See the IPsec Protocol description in the section, Manual IPsec: Security Policy . The IPsec
Protocol, in conjunction with the destination IP address and the Security Parameter Index
uniquely identify the SA.
Mode
See the Mode description in the section, Manual IPsec: Security Policy . The Mode must
match the setting chosen on the remote side.
Unique Number
This is the same number, from 1 through 16,383 that was configured in the SP. Configuring the
same Unique Number for the SA and SP ensures this SA is used for the SP.
Encryption Algorithm
This is the encryption algorithm used to protect the IP payload. Each algorithm must use a key of
a specific length.
Encryption Password
This is the key the encryption algorithm uses to provide confidentiality. The mandatory length of
each key is determined by the encryption algorithm.
The encryption key can be entered as an ASCII character string in double quotes or as
hexadecimal sequence starting with 0x. If the key is entered as an ASCII string, each character is
treated as an 8-bit quantity. E.g. “12345678” is a 64 bit key, equivalent to 0x3132333435363738.