Digi-Star RF DataLink Operators Manual - Manual (Page 21)

Operators Manual
D3664 15
When you select, [All Loads at one time. PC controls loads] or [All
pens and Recipes at one time to the mixer. Mixer controls the loads]. The “Distribute All
Pens to All Mixers” option will appear. This option is set to [No] if the mixers have zones
assigned to them. It will only send the correct zone to the correct mixer if the option is set to
[NO].
Full Load Delay
This option is used with a bunk reader program. If the bunk reader program sends pens to
Datalink when new pens are available, Datalink will wait until there are pens to make a
complete load to send to a mixer.
Defaults – Delivery Sorting
Sort by Incoming File – This setting will allow Datalink to send the pen data out in the same
order as sent by the third party software.
Sort by Pre-Defined Pen List – This setting allows you to set a predefined pen list. Datalink
will always send out the pen list in the same order, no matter how the file is sorted by the
third party software.
Sort by Pre-Defined Recipe per Mixer – This setting allows you to set a recipe order
depending on each mixer. Example: Mixer one sort’s recipes in this order R3, R2, R1.
Mixer two sorts in this order R1, R2, R3.
Sort by Zone – This setting will send out the pens in the order of the zone number: Zone 1-9