Digi-Star EZII Escape Computer Command Set User Manual
Page 30
EZII Escape Computer Command Set
30
D36 48 Rev G
November 30, 2009
6, 26
Transmit weight display whenever the displayed weight changes to a different value.
& 36
-
Same data format as setting 1.
7
Transmit comma delimited data which includes the basic weighing information 1 time per second.
-
Includes Gross Weight, display unit, weight tag (GR, M+, etc...), Total Rotation Count, Date
& Time with seconds.
-
Ends with a <CR>,<LF>. (Carriage Return- Dec. 13, Line Feed-Dec. 10).
Output example:
1 2 3 4
1234567890123456789012345678901234567890
" 280,LB,GR, 187,03JL03, 3:41:21"
8
Transmit comma delimited data which includes the basic weighing information once every 5
seconds.
-
Same data format as setting 7.
9
Selection #9 is reserved.
10
Transmit comma delimited data which includes the EID Tag Reader information once every 2
seconds.
-
Includes Gross Weight, display unit, weight tag (GR, M+, etc...), Date & Time.
-
Ends with a <CR>,<LF>. (Carriage Return- Dec. 13, Line Feed-Dec. 10).
-
For more details on data field format see “Send All EID Records Command” response
sw550/sw2600 format.
Output example:
1 2 3 4 5 6
123456789012345678901234567890123456789012345678901234567890123456789
" EID Data (right justified), 1400,LB,$,GR,08/12/03,14:09,C"
Checksum^
The Check Sum calculation is found at the end of this section.
11
Transmit comma delimited data which includes the "serial gross weight" 2 times per second.
See service Bulletin #31 for additional information about the “Serial Gross Weight”.
The serial gross weight data will be sent at 9600 Baud, 1 start bit, 7 data bits, 1 EVEN parity
bit and 1 stop bit on pin 2 (COM #1 Tx line) of a J904 or J905 Serial / Printer connector.
Please Note: This setting may not be available if a radio is installed in the indicator for
communications to a Cab Control or Datalink system.
-
Starts with < STX> (Start of TeXt - Dec. 2).
-
Six digit Serial Gross Weight “whole number” value (ie.1000 not 100.0).
-
"LB" or "KG" unit of measure.
-
Space character.
-
"SG" to identify Serial Gross weight.
-
The <ETX> (End of TeXt - Dec. 3) control character.
-
Checksum Character (C) value that includes all bytes starting after the <STX> up through,
but not including the <ETX>. The Check Sum calculation is found at the end of this
section.
-
Ends with a <CR> (Carriage Return- Dec. 13).