Digi-Star DataLink - Manual (Page 19)

Operators Manual
D3664 15
Modify Recipe
To set the Modify Rations Enabled Selection, from the main
menu select [Systems], [Defaults], [Processing]. This will display
the Process Settings screen.
This selection determines whether you will allow rations to be
modified in the RF DataLink program. If you select [Yes], you
will be able to edit a ration.
Selecting [No] will not allow ration modification within the RF DataLink program.
Ration data is created and sent from third party software. If you edit a ration within the RF
DataLink program, you will not be able to obtain accurate reporting on that ration unless you
make the identical changes within third party software.
Modify Pen Enabled
To set the Modify Pens Enabled Selection, from the main menu
select [Systems], [Defaults], [Processing]. This will display the
Process Settings screen.
This selection determines whether you will allow pens to be
modified in the RF DataLink program. If you select [Yes], you will
be able to edit a pen.
Selecting [No] will not allow pen modification within the RF DataLink program.
Pen data is created and sent from third party software. If you edit a pen within the RF
DataLink program, you will not be able to obtain accurate reporting on that pen unless you
make the identical changes within third party software.
Manual Load Making
To set the Manual Load Making Selection, from the main menu
select Systems, Defaults, Processing. This will display the
Process Settings screen.
This selection determines whether you will allow a user at the RF
DataLink to enter a manual load. In the Auto Process, the RF
DataLink will automatically make your loads, if you select [Yes] to allow manual load
making, an operator can override the RF DataLink and force the next load.
If you select No, manual load making is disabled.
Wait for Acknowledge
To set the Wait for Acknowledge Selection, from the main
menu select Systems, Defaults, Processing. This will
display the Process Settings screen.
This setting determines whether the RF DataLink program
will wait for a response from an operator for any program-
generated message.
If you select [Yes], an operator must respond to the message before the program will
resume. If you select [No], the message will automatically time out after 10 seconds and the
program will resume.