HP Velotechnik Go SwissDrive system for HP Velotechnik - Manual (Page 17)

Notes for the user
15
symbol will be shown in the status bar. This
will continue to be displayed until you access
the telephone menu of your Evo (please refer
to Chapter 10).
Servicetool:
Your well-equipped specialist dealer should
have the GO S
WISS
D
RIVE
Servicetool, which
can be used to reconfigure various settings on
your vehicle. Whenever the display is
connected to the Servicetool via the USB or
Bluetooth interface, this is shown by the
Servicetool symbol.
Fault:
If a fault occurs in the drive system of your
vehicle, a notification will appear on the
display. A pop-up will appear briefly first
(please refer to Chapter 14). Then the fault
symbol will be shown in the status bar. More
detailed information on the current fault and
any action that may be required is described
in the service menu (please refer to Chapter
12). The fault symbol is cleared when you
access the service menu or if the fault is no
longer present.
Temperature warning:
As an early safeguard against potential faults in
the system, advance warnings may appear on
the display. In particular, these include the
motor and battery overheating warning.
Before the motor or battery overheats and in
order to protect the system, power is
reduced and the display informs you
accordingly. A pop-up will appear briefly first
(please refer to pop-ups section). Then, if the
operating temperatures of the motor and
battery remain above the warning threshold,
the temperature warning symbol will be
displayed in the status bar in the form of a
thermometer. Once the temperature of the
motor/battery has fallen below the warning
limit following a change in your riding style,
the symbol in the status bar will disappear.
Note: Adapt your riding style and/or
assistance levels as instructed if you wish
to avoid a temporary power reduction or
total loss of assistance. You can do this
either by lowering the assistance level or
by shifting down into a gear with a lower
gear ratio in order to reduce the
temporary overloading of drive
components.
Battery charge state:
The symbol near the right edge of the status
bar indicates the current charge state of the
battery. The symbol is segmented into 9 bars,
with each bar representing 10% of battery
capacity. The table below provides a detailed
description of how the display changes with
state of charge
Display of battery charge state:
9 bars:
100% – 90%
8 bars: 89% – 80%
7 bars: 79% – 70%
6 bars: 69% – 60%
5 bars: 59% – 50%
4 bars: 49% – 40%
3 bars: 39% – 30%
2 bars: 29% – 20%
1 bar: 19% – 10%
0 bar: 9% – 0%
A white bar indicates that the motor is
operating in recuperation mode.
Note: The charge state indicator is always
relative to the maximum capacity of the
battery at the current time. It should be
noted that the maximum charge capacity of
a rechargeable battery could diminish as
the number of charge cycles increases.
Main menu
The main menu contains all the essential
information needed during a ride. By default,