Lynx Studio LT-FW - Manual (Page 18)

Page 18 of 43
7. Click “Hardware Settings…” from the Audio menu. Verify that the LynxLTFW appears
as the Output device. Click “OK”.
8. Click “Play” from the Peak transport. You should see meter activity and the counter
progressing.
9. Open the Lynx Aurora Remote Control application. Click the Analog I/O tab. Check for
meter activity for Analog Outputs 1&2. If you have speakers or headphones connected to
your destination device, you should be hearing audio as well.
If the test did not operate as described or you received any errors, please refer to Section 00 ,
Troubleshooting Troubleshooting .