Lynx Studio LT-FW - Manual (Page 25)

Page 25 of 43
2)
This drop-down menu allows for selection of the signal source that will be routed to
the digital outputs. “ANALOG IN”, “AES IN” and “LSLOT In” are global
selections, affecting all analog output channels. “LSLOT” routes signals from the
computer via the FireWire connection. Choosing “REMOTE” allows individual
sources to be assigned from the Monitor Source section of the DIGITAL I/O Page of
the Aurora Remote Control application.
2!
The LSLOT Outputs are not typically available independently, but mirror either the
Analog or Digital Outputs on the Aurora. This drop-down menu allows selection of
whether the Analog Outputs or Digital Outputs are selected to mirror to LSLOT. This
is not pertinent for the LT-FW since its driver allows the Aurora I/O to be selected
from within the host computer.
2@
This drop-down menu determines whether the Aurora front panel meters display
activity for the digital or analog inputs and outputs.
2#
This checkbox activates dual-wire mode for the AES inputs. See the Aurora User
Manual for information.
2$
This checkbox activates dual-wire mode for the AES outputs. See the Aurora User
Manual for information.
2%
This checkbox activates the SynchroLock clocking system. See the Aurora User
Manual for information.
2^
This display shows the status of the SynchroLock clocking system. See the Aurora
User Manual for information.
7.3.3 Mixer Menu
In the Windows version of ARC, the
“Mixer” menu in the top left corner
identifies the connection medium for the
Aurora, and provides access to the “About
Aurora Remote..,” screen.
In the OS X version, the equivalent is the
“Aurora” menu.