Measurement Computing USB-5100 Series - Manual (Page 18)

USB-5100 Series Software Help Working with USB-5100 Series Data Loggers
Configure Alarms
To set an alarm to trip when a sensor reading rises above or falls below a specified value, complete the
following steps:
1. Click Alarms in the Launch Logger dialog box.
If the Alarms button is disabled, make sure the Logging Mode is set to Normal or Statistics. Alarms are not
available for USB-5100 Series loggers when the Logging Mode is set to Burst.
2. In the Alarms dialog box, select the sensor that you want to have an alarm.
Figure 8. Filter Series Dialog Box
18