ROTEL RDV-1092 - Manual (Page 29)

29 29 English
HDMI Color Format
There are three different color space stan-
dards for digital TV monitors: RGB, YCrCb
4:2:2, and YCrCb 4:4:4. Matching the
output of the RDV-1092 to color format is
essential when connecting the monitor with
HDMI cables. Typically, the AUTO setting
will detect the proper format for the digital
TV monitor automatically. If not, use one of
the manual settings:
• AUTO: The DVD player detect information
from the TV Monitor and selects the cor-
rect color space automatically. (default)
• RGB: Use when your HDMI connected
digital TV monitor supports the RGB color
format.
• YCrCb 4:2:2: Use when your HDMI con-
nected digital TV monitor supports YCrCb
4:2:2 color.
• YCrCb 4:4:4: Use when your HDMI con-
nected digital TV monitor supports YCrCb
4:4:4 color.
Enhancement
The built-in video scaler has optional edge
enhancement to increase the sharpness
of the picture at the expense of somewhat
higher video noise. This setting allows you
the choice of using edge enhancement with
softer video images.
• OFF: Turns off edge enhancement (de-
fault).
• LOW: Turns on edge enhancement, with
minimal settings.
• MEDIUM: Turns on edge enhancement,
with moderate settings.
• HIGH: Turns on maximum edge enhance-
ment.
MORE INFORMATION
Troubleshooting
If you are experiencing difficulties, consult the
following list for possible solutions:
Power
Power does not come on.
• Check that the power plug is inserted se-
curely.
Operation
Region Code Error.
• Make sure the Region Code of the inserted
disc matched the code shown on the back
of the unit.
Unit will not work or operates er-
ratically.
• Microprocessor malfunction due to light-
ning or static electricity. Turn off the power
and unplug the power cord. Connect the
power cord again.
• Moisture condensation caused by a sud-
den change of temperature or humidity.
Turn off the power, then turn it on a few
hours later.
• If only one specific disc will not play, the
disc may be defective.
Remote does not work.
• Check the battery installation, install new
batteries, aim remote at unit.
Picture
Picture is noisy.
• The player is connected to a VCR directly
and the copy guard function is activated.
Connect the player directly to the TV.
Cannot get correct picture on TV.
• Connect the RDV-1092 to the TV with the
correct kind of cable.
• Make sure that the Video Output setting
matches the correct resolution of your TV.
You cannot display progressive scan video
on standard definition TVs.
• Make sure that the PAL/NTSC setting
matches your TV.
Picture does not fill screen.
• Set ASPECT RATIO correctly.
HDMI LED flashing continuously and
no picture.
• HDMI components must be Ver. 1.1 com-
patible.
• HDMI cables must be 5 meters or less in
length.
No picture at Component video.
• Most DVD Video discs are Macrovision,
HDCP compliant. Set the Output format of
High Definition setup change to Progressive
(480p/576p) or interlace (480i/576i).
Audio
No sound.
• Check the audio cable connection and
input settings on preamplifier.
Garbled sound.
• Clean the disc surface.