Tascam MMR-8 - Manual (Page 79)

TASCAM MMR-8 Owner’s Manual • Chapter 4 • MMR-8 Operation 79
Direct time code
entry
Use the numeric keys to type in the time code. The keyed time code will replace
any existing time code in the display. Use this method if the time code position is
known. Pressing CLR will reset any existing time code in the register to zero,
making it easier to enter new time code numbers.
Capture the
time code
Press CAPT during play, record or while stopped. This copies the “play head”
time code shown in the top line, at the moment the CAPT key is pressed, to the
entry register on the bottom line.
Recall, Trim,
and Store
a Register
Recall and trim one of the ten memory registers (using RCL+0 - 9), or one of the
special-purpose registers (using RCL+SHIFT+0 - 9), and press the STO key. The
register time code value is then copied to the entry register.
The time code value in the entry register can be trimmed, as required, by using the Wheel or Up/Down
arrow keys to increment or decrement the time code before any other action is taken on the time code.