Tascam MMR-8 - Manual (Page 82)

TASCAM MMR-8 Owner’s Manual • Chapter 4 • MMR-8 Operation 82
Open Open places a segment of silence into the selected track(s) equal to the time
between the In point register and the Out point register. It functions like an Insert,
slipping all subsequent material on the selected tracks downstream in time. Another
way to say it is that all material on the selected tracks from the In point onward is
moved (or rippled) so that it now begins at the time code location in the Out
register. If the In point is within an audio segment on the track, the segment is split
at the In point, with material before the In point remaining in place and material
after the In point shifted to the position defined in the Out register.
Undo Undo un-does the last edit operation, which includes undoing the last recording that
was ended by pressing the “stop” transport key (only in Non-Destructive Record).
There are 100 levels of undo available, accessed by selecting SHIFT and then
pressing SEL7 one or more times (while the SHIFT key is active).
Redo Redo re-does the last undo edit operation, including restoring recordings that were
undone (only in Non-Destructive Record). There are 100 levels of redo possible,
accessed by selecting SHIFT and then pressing SEL8 one or more times while the
SHIFT key is active.
Undo and Redo put the time code registers and Selected tracks to the state they
were in before the edit (undo) or after the edit (Redo).
EDIT Pressing this key (while in the Normal state) allows the SEL keys to select which
track(s) will be later edited (using the SHIFT+SEL edit functions described above).
The suggested sequence of keystrokes to follow for editing is:
Press the EDIT key to enter the Edit Track Mode, then the SEL key for the track(s)
to be edited.
Set the In and Out points to define the range of material to be affected on the
selected track(s).
Press SHIFT + SEL for the desired edit function (Cut, Clear, Copy).
Set the In point to the time code location where the material on the clipboard is to
be placed.
While the EDIT key is still enabled (amber LED is on), press the SEL key for the
track(s) where the material on the clipboard is to be placed.
Press SHIFT + SEL for the desired edit function (Paste, Insert)
In
Register
Out
Register
After Open
Before Open