Tascam MMR-8 - Manual (Page 83)

TASCAM MMR-8 Owner’s Manual • Chapter 4 • MMR-8 Operation 83
This completes the Edit operation. Note that Open operates differently in that it
does not place material from the Clipboard into a track, but instead references the
length of time between the In and Out registers and moves the downstream
material by that amount.
If material from a single track is placed on the clipboard, but multiple destination
tracks are selected, only the first selected track (counting upwards from 1 to 8) will
be used as the target for the Paste or Insert.
If multiple tracks are placed on the clipboard, then multiple destination tracks can
be selected. Selecting the same number of target tracks as used for the clipboard
operation insures the material will be placed on only those tracks. If a different
number of target tracks are selected, the Paste or Insert will place the clipboard
material consecutively on the selected tracks, starting with the first selected track,
up to the limit of the number of tracks selected. For example:
If material is Copied from Track 1, then tracks 3, 4, 6, and 8 are Selected for the
target, the Paste operation will only put material on track 3.
If material is Copied from tracks 2, 4, and 6, then tracks 1 through 8 are all
selected, the Paste operation will place material on tracks 1, 2, and 3. If only three
tracks are selected for the Paste (for example, tracks 3, 5, and 7) then the material
will go on those tracks in order.