Initialization, All lines registered – Teo IP Phone 7810-TSG Installation User Manual
Page 20
Teo IP Phone 7810 TSG Series Installation Instructions
Page 20
13-280138 Rev. H
Initializing...
APP VERSION 05.04.16
LINE ID=
DELETE CLEAR 123
AUTH ID=
DELETE CLEAR 123
SIP PSWD=
DELETE CLEAR 123
ALL LINES REGISTERED
I
I
n
n
i
i
t
t
i
i
a
a
l
l
i
i
z
z
a
a
t
t
i
i
o
o
n
n
With the application of power, the phone’s operating software is loaded into internal
memory. During this interval, the Message Waiting Indicator will be illuminated. Upon
completion, the display will show the current software version.
The display will show progress messages while establishing the communication layers.
Many configuration settings can be set automatically by a DHCP server and telephone
update server. DHCP should be used if available; it is enabled by default.
If DHCP and update servers are available and configured properly, the phone will prompt
for a Line ID and SIP Password the first time that the phone is connected to the network.
You may also be prompted for an authentication ID if required by the system.
•
Enter the appropriate Line ID (phone) number, and then press the
OK
key. This
would typically be the phone number used for station-to-station calls.
•
If prompted, enter the appropriate authentication ID number, and then press the
OK
key. Leave this entry blank if no authentication ID is required.
•
Enter the appropriate password, and then press the
OK
key. Leave this entry blank if
no password is required.
•
If the update server protocol and IP address are not supplied by DHCP, configure
these items as shown on the following page.
During the registration process, the line key indicators will flash red. When lines are
registered with the proxy server, the indicators will turn solid green momentarily, and then
go out. The following status message will be displayed when registration is complete.
The idle display will then appear, indicating that the phone is ready for use.