Configuring keys, Key labels – Teo IP Phone 7810-TSG Installation User Manual
Page 36
Teo IP Phone 7810 TSG Series Installation Instructions
Page 36
13-280138 Rev. H
SELECT A KEY
12=UNUSED ¤
LINE FA DSS SPDIAL
12=UNUSED £
ACD UNUSED
LINE KEY OPTIONS ¤
ADD REMOVE LABEL
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
i
i
n
n
g
g
K
K
e
e
y
y
s
s
You can assign line appearances, feature activators, and DSS/BLF/Speed Dial numbers to
keys, and set up the
VOICE MAIL
and
SPKR
keys by using this option.
From the Installation Options menu, select KEYS.
(
SETUP
→ INSTL → KEYS)
The status indicator for each key will indicate the current setting:
Green
– Line Appearance or DSS/BLF
Red
– Feature Activator
Off
– Unused or Speed Dial
On the phone or 8030X Button Expansion Module, press the line or multifunction
key to be programmed.
The selected key’s indicator will alternately flash red and green.
Select LINE (Line Appearance), FA (Feature Activator), DSS (Direct Station
Select/Busy Lamp Field), SPDIAL (Speed Dial), ACD (Automatic Call Distribution), or
UNUSED from the menu.
Programming procedures for each key type are described below.
When finished editing keys, press the
OK
key to return to the Installation Options
menu or press the
SETUP
key to exit Setup Mode.
K
K
e
e
y
y
L
L
a
a
b
b
e
e
l
l
s
s
The line and multifunction keys on the phone are labeled on the display. You can
customize the labels for Line Appearance, Speed Dial, and DSS/BLF keys by entering user
names or other identifiers.
Paper labels are used on the 8030X Button Expansion Module. 8030X label templates for
Microsoft Word can be downloaded from
www.teotech.com
.
After selecting a multifunction key, the key type, and the EDIT menu selection,
press the Left or Right Arrow key repeatedly until LABEL is shown in the menu.