Edit existing line key – Teo IP Phone 7810-TSG Installation User Manual
Page 38
Teo IP Phone 7810 TSG Series Installation Instructions
Page 38
13-280138 Rev. H
NAME=Nick Robinson
DELETE CLEAR abc
01-03: 4321
EDIT ADD REMOVE
LINE KEY OPTIONS ¤
ID NAME AUTHID PSWD
LINE KEY OPTIONS £¤
SHARE CODEC PTIME JTR
LINE KEY OPTIONS £
ADD
REMOVE
LABEL
SHARED LINE=DISABLED
ENABLE DISABLE
E
E
d
d
i
i
t
t
E
E
x
x
i
i
s
s
t
t
i
i
n
n
g
g
L
L
i
i
n
n
e
e
K
K
e
e
y
y
If the selected key is currently programmed as a line key, the display will show the key
number and line ID. A range of consecutive key numbers will be shown if the line ID is
assigned to multiple keys (a multiple line appearance group).
Select ADD to add the next key to the group. A group can contain up to five keys.
Select REMOVE to remove the last key from the group.
Select EDIT to change the settings for the key.
Select NAME.
Enter the caller ID display name with the dial pad, up to 24 characters maximum.
Caller ID name display may not be supported by some SIP servers.
Press the
OK
key.
Line sharing as described below is for use with Avaya and other systems that support
shared lines. Leave the Shared Line setting disabled when connected to a Teo UC
system. The share setting is not used for multiple registrations of the same Line ID as
the primary line.
Press the Left or Right Arrow key repeatedly until SHARE is shown in the
menu.
The AUTHID (authentication ID) and PSWD (SIP authentication password)
may be required for this line, and the codec, ptime, and jitter buffer options
may need to be changed; consult your system administrator.
Select SHARE to control sharing of this line with other telephones.