Thinklogical Secure Console Server Manual User Manual
Page 66
S e c u r e C o n s o l e S e r v e r M a n u a l , R e v . K , J u l y , 2 0 1 3
Page 66
Default:
1
Description:
N0
Modem performs handshake only at communication standard specified by S37 and the B
command.
N1 Modem begins handshake at communication standard specified by S37 and the B command. During handshake, fallback to a lower
speed can occur.
Command:
O
n
Return Online to Data Mode
Values:
0, 1, 3
Default:
None
Description:
O0
Exit online command mode and return to data mode (see
+++AT<CR>
escape sequence).
O1
Issue a retrain and return to online data mode.
O3
Issue a rate renegotiation and return to data mode.
Command:
P
Pulse Dialing
Values:
P, T
Default:
T
Description:
Configures the modem for pulse (non-touch-tone) dialing. Dialed digits are pulsed until a T
command or dial modifier is received.
Command:
Q
n
Result Codes Enable/Disable
Values:
n
= 0 or 1
Default:
0
Description:
Q0
Enable result codes.
Q1
Disable result codes.
Q2
Returns an
OK
for backward compatibility with some software.
Command:
Sr=
n
Set Register Value
Values:
r
= S-register number;
n
varies
Default:
None
Description:
Set value of register S
r
to value of
n,
where
n
is entered in decimal format (e.g., S0=1).
Command:
Sr?
Read Register Value
Values:
r = S-register number
Default:
None
Description:
Read value of register Sr and display it in 3-digit decimal form (e.g., S2? gives the response 043).
Command:
T
Tone Dialing
Values:
P, T
Default:
T
Description:
Configures the modem for DTMF (touch-tone) dialing. Dialed digits are tone dialed until a P command or
dial modifier is received.
Command:
Vn
Result Code Format
Values:
n = 0 or 1
Default:
1
Description:
V0 Displays result codes as digits (terse response).
V1 Displays result codes as words (verbose response).
Command:
Wn
Result Code Options
Values:
n = 0, 1, or 2
Default:
2
Description:
W0 CONNECT result code reports serial port speed, disables protocol result codes.
W1
CONNECT result code reports serial port speed, enables protocol result codes.
W2
CONNECT result code reports line speed, enables protocol result codes.
Command:
Xn
Result Code Selection
Values:
n = 0–7