Triplett CamView PTZ – PN: 8000 - Manual (Page 15)

To turn the unit on, press for about 2 seconds and release when the
unit powers up. After depleting the battery, connect the supplied battery charger
to the power jack (23). The red Charge Indicator should turn on. Charge
the battery until the indicator turns off. This could take 4 to 5 hours. When the
Charge Indicator turns off, the battery is approximately 90% charged.
The charging time can be extended for about 1 hour to ‘top off’ the battery
charge. To obtain the best battery life, limit charging time to about 8 hours.
Leaving the battery on continuous charge may reduce the battery life.
• The CamView can be used while its batteries are being charged, however,
the charging time will be increased.
Page 13
2.4 Connecting and Charging the Battery Cont.
POWER
If the CamView behaves abnormally, it can be reset to the
factory default settings by pressing the RESET button (22).