Triplett CamView PTZ – PN: 8000 - Manual (Page 35)

Page 33
This feature is intended to preserve the charge on the battery if the prod-
uct is unused for some period of time. The ‘Auto power off’ feature can be
Disabled if desired.
Use or to move the cursor to ‘Auto power off’. Then use or to
select the desired ‘time-out’ interval. Select ‘Disabled’ to allow the CamView
to run continuously. ‘Apply’ the change by pressing .
3.8.2 Keypad tone
The ‘Key Beep’ can be turned on or off.
Use or to move the cursor to ‘Prompt sound’. Then select ‘Off’ or ‘On’
using the or buttons. ‘Apply’ the change by pressing .
3.8.3 Language
English or Chinese can be selected as the operational language for the
CamView. Use or to move the cursor to ‘Language’. Then select
‘English’ or ‘Chinese Symbols’ using the and buttons. ‘Apply’ the
change by pressing .
3.8.4 Brightness
The brightness of the menus can be set as desired.
Use or to move the cursor to ‘Brightness’. Then select a brightness
from 0 to 7 using the and buttons. ‘Apply’ the change by pressing
ENTER
OPEN
ENTER
OPEN
ENTER
OPEN
ENTER
OPEN
3.8.5 Automatic Address Search
The CamView PTZ makes it easy to find the address of a PTZ controlled cam-
era. The PTZ Protocol and Baud Rate must be known to use this feature. This
is usually not a problem because installers often use the same protocol and
baud rate in all their installations.
is usually not a problem because installers often use the same protocol and
baud rate in all their installations.
The Address Search feature must be initialized each time the product is
turned on. If the product is turned off and back on, the feature must be