Triplett CamView PTZ – PN: 8000 - Manual (Page 25)

Page 23
3.3.2 Setting PTZ Parameters (Details) Cont.
F. Testing PTZ communication
If the PTZ setup is correct, and the camera is operating properly, it should
respond to the buttons on the CamView keyboard. Set the CamView to the ‘PTZ
controller’ mode. The video image from the camera should be visible on the LCD
screen. Press the buttons on the keyboard to verify that the camera responds to
the CamView’s commands.
Some cameras may not respond to the Aperture or Focus settings because these
are automatically set by the camera. There may be a software setting in the
camera menu that allows the camera to respond to manual Aperture and Focus
commands. To allow manual operation of these settings, the camera menu must
be accessed and the appropriate settings altered.