Airlink AML001 User Manual
Page 35
PCI Modem Card User's Manual
34
Receive Frame Count
Number of LAPM frames received by the client
during this call. Count wraps around at 65535.
Receive Frame Error
Count
Number of frames received in error by the client.
Retrain by Local Modem Number of retrains or rate renegotiations requested
by the modem.
Retrain by Remote
Modem
Number of retrains or rate renegotiations requested
by the remote modem.
Call Termination Cause
Reason for call ending. Only valid after call ends.
Result codes are as follows:
!
0 = local modem command: ATH, DTR drop.
!
1 = remote modem: cleardown, loss of signal.
!
2 = no answer, busy, etc.
!
3 = training failure V.90 or V.34.
!
4 = protocol failure if required by \N4, for
example.
Robbed-Bit Signaling
For PCM connection only, a hexadecimal 6-bit
pattern of T1 frames with robbed-bit signaling.
Digital Loss (dB)
For PCM connection only, the downstream digital
loss.
Remote Server ID
—
L<value>—Speaker Volume
Use this command to set the monitor speaker volume setting when the
speaker is on.
L0
Low volume.
L1
Low volume.
L2
Medium volume (default).
L3 High volume.
M<value>—Speaker Control
Use this command to turn the monitor speaker on or off.
M0
Speaker is off.