Airlink AML001 User Manual
Page 39
PCI Modem Card User's Manual
38
•
CALL WAITING DETECTED
X5
Busy detection is enabled; blind dialing is disabled. The
dialing cannot be conducted unless a dial tone is detected. If
dial tone is not detected within the time specified by register
S6, the NO DIAL-TONE result code will be reported. The
following result codes are supported:
•
OK
•
RING
•
NO CARRIER
•
ERROR
•
NO DIALTONE
•
BUSY
•
CONNECT <RATE>
•
RRING
•
NO BONGTONE
•
DELAYED
•
BLACKLISTED
•
WARBLE
•
CALL WAITING DETECTED
Y<value>—Long-Space Disconnect
This command is supported to ensure compatibility with communication
software that issues the Y0 command. Long-space disconnect is always
disabled.
Y0
Disables long-space disconnect (default).
Z<value>—Reset and Recall Stored Profile
Use this command to force the soft modem to go on-hook and restore a
profile saved by the &W command. Soft modem products have two stored
profiles and the active profile. The <value> parameter selects the stored
profile to copy into the active profile.
Z0
Reset and restore stored profile 0.
Z1
Reset and restore stored profile 1.
&B<value>—V.32 Auto Retrain
This command is supported to ensure compatibility with communications
software that issues the B1 command. The B0 version of this command is not
supported.
&B0
Disable V.32 auto-retrain (not supported).
&B1
Enable V.32 auto-retrain (default).
&C<value>—Data Carrier Detect (DCD) Control