Airlink AML001 - Manual (Page 45)

PCI Modem Card User's Manual
44
\Q0 Disables flow control (same as &K0).
\Q1 XON/XOFF software flow control (same as &K4).
\Q3 RTS/CTS to DTE (same as &K3) (default).
\R<value>—Ring Indicator Signal Off After Answer
This command is supported to ensure compatibility with communications
software that issues the \R0 command.
\R0 Ring indicator signal is off after the telephone call is answered.
\T<time delay>—Inactivity Timer
Use this command to specify the delay time used by the inactivity timer. The
delay time is the length of time in minutes that the modem waits during
periods of inactivity before disconnecting. Periods of inactivity are defined
by no data being sent or received by the DCE. To disable the inactivity timer,
use the T0 command. The delay time may also be specified in register S30.
This function is only applicable in buffer mode.
\T0 Inactivity timer disabled (default).
\T1—\T255 Specifies the length of time in minutes that the modem will
wait before disconnecting when no data is sent or received.
\V<value>—Protocol Result Code
Use this command to enable or disable protocol result codes.
\V0 Disables protocol result code appended to DCE speed.
\V1 Enables protocol result code appended to DCE speed (default).
\V2 Enables protocol result code appended to DCE speed (same as
\V1).
%B—View Numbers in Blacklist
If blacklisting is in effect, this command displays the numbers that are
currently blacklisted, failed, or delayed. The ERROR result code appears for
countries that do not support blacklisting.
%C<value>—Data Compression Control
Use this command to enable or disable V.42 bis and MNP class 5 data
compression. On-line changes do not take effect until a disconnect occurs.
%C0 V.42 bis/ MNP 5 disabled. No data compression.