Alinco DR-SR8 - Manual (Page 89)

87
Chapter 7 Maintenance
7.3 Reset
There are 3 types of reset modes in DX-SR8.
1. ALL reset: Resets all customized parameters and memories to return to the factory-default
condition.
2. Memory reset: Resets memory channel data only.
3. System reset: Resets functions and Set mode parameters. Memory data remain unchanged.
Procedure
* ALL reset: Turn off then turn on with [FUNC] key pressed.
* Memory reset: Turn off, then turn on with [M/KHz] and [RF] keys pressed together.
* System reset: Turn off, then turn on with [V/M] key pressed.
NOTE: • None of reset can restore previous data once the reset is completed. It is recommended to
write important setting parameters and/or memory frequency information on blank pages
available at the end of this manual for your future references.
• It is recommended to use reset features whenever you get lost with the explanation of this
manual until you get familiar with the functions of DX-SR8.
7.4 Cleaning
Regular cleaning is recommended to use this product in appropriate conditions.
* Be sure turn off and remove from the power source to clean the product.
* Use of cleaning devices made especially for delicate equipment such as personal computer
or digital video/camera, like special wet-tissues, anti-static brushes, dry rubber-blower etc. is
suitable to clean the surface of this product and accessories also.
* Never use thinner, benzene, alcohol or any liquid solvent otherwise damages the product and
voids warranty.
* Never use unauthorized contact-cleaners, oil, spray-blower and other materials may be used
to clean home appliances. They may not be suitable for delicate products like transceivers.
Troubles caused by use of such materials will void the warranty of this product.
All LCD segments