H3C Technologies H3C S5800 Series Switches - Manual (Page 24)

14
S5800-32F panel views
Front panel
Figure 16 S5800-32F front panel
(1) Interface card slot 1 (2) 100/1000Base-X SFP port (3) 100/1000Base-X SFP port LED
(4) Seven-segment LED (5) Port mode LED (6) SFP+ port LED
(7) Logo plate (A console port and a USB port are under this logo plate)
(8) System status LED (SYS)
(9) Power module 1 status LED (PWR1)
(10) Power module 2 status LED (PWR2) (11) SFP+ port
(12) Port LED mode switching button
To use the console port and USB port, open the logo plate, as shown in Figure 4 and Figure 5 .
NOTE:
The S5800-32F switch comes with the expansion interface card slot covered by a filler panel. In this figure,
an LSW1SP4P0 interface card is installed in the slot.
Rear panel
Figure 17 S5800-32F rear panel
(1) Power module slot 1 (2) Power module slot 2
(3) Hot swappable fan tray (4) Management Ethernet port
(5) Grounding screw (6) ACT LED for the management Ethernet port
(7) LINK LED for the management Ethernet port