Epson SR-600 - Manual (Page 101)

Rev.A Hardware Specifications 5-19
Developer's Guide SR-600 Confidential
CD-ROM Drive(Optional)
Interface: ATAPI (Primary)
Transfer mode: PIO Mode4, Single word DMA Mode2, Multi word DMA Mode2
Readable media: CD-ROM (mode1, mode2), CD-ROM XA (mode2 form1,form2), :CD-
DA, Photo CD, CD-I (mode2 form1,form2), CD-I Ready, CD-I Bridge, CD-WO, Video CD,
Enhanced Music CD (CD Plus), CD-RW
Media size: 12cm or 8cm
Size: 128(W) x 127(D) x 12.7(H) mm
Power: single +5V
Reading: 650mA, seek/Spin-up: 750mA, peak : 1500mA
Weight: 245g (typ.) Drive only
Manufacture: EPSON
Model number: OI-S02
• CD-ROM drive is connected to the Primary IDE, and operates as Slave Drive.
• It cannot play music CD.
CompactFlash Card(Optional or Specified Product)
It is possible to use a CompactFlash card mounted in SR-600 as a substitute for a HDD or CD-
ROM. The compact flash card is directly connected to the Primary IDE bus and operates in the
mode called True IDE mode. When the compact flash card is mounted as a substitute for a HDD,
it operates as a Master Drive. When compact flash card is mounted as a substitute for a CD-
ROM, it operates as a Slave Drive. Either Type I(3.3mm height) or Type II(5mm height) card can
be used. In addition, the power is +3.3V.
The CompactFlash Association, which establishes the CompactFlash standard, establishes two
specifications. Also, two power level is defined in the CF+ card. Level0 is same as the
CompactFlash standard. Level1 is defined that the maximum electric current is 500mA although
the power supply is 3.3V or 5V. Although the Host side is not required to support Level1, it does
not creat a problem if 500mA electric current flows in the SR-600.
Table 5-7 The differences of Compact Flash and CF+
Operation mode Maximum electric current
PC Card
Memory code PC Card
I/O mode
True IDE mode +5V +3.3V
Compact
Flash O O O 100mA 75mA