Epson SR-600 - Manual (Page 97)

Rev.A Hardware Specifications 5-15
Developer's Guide SR-600 Confidential
PCI Board
PCI Slot
The PCI bus signal from the motherboard is directly connected to the PCI slot through the PCI
board. Refer to Table 10, “Assignment of PCI slot signalsM,” on page 12 for the pin assignments.
IDSEL
• Slot #1: AD26
❏ +3.3V/+5V/ +/-12V power supply
❏ PCI card size that can be mounted
The PCI card that fit within the range shown below can be mounted.
However, the PCI card size shown below fits when the under frame under the main cover is
removed. The card size, that can be mounted from the access point located to the side of the
SR-600, is smaller than the size shown below.
5-11 Mountable (when under frame is remved) PCI card size
5-12 PCI card size that is inserted from the side of SR-600
95 or less
145 or less
< Card surface >
unit:mm
95 or less
145 or less
< Card surface >
unit:mm