Epson SR-600 - Manual (Page 112)

6-6 Peripherals/Option Installation Rev.A
Confidential
MSR unit (DM-MS123/DM-MS112) can be connected to the connector located on the right side
of the unit. When you connect the MSR unit, remove the connector cover and stabilize it with
screw. When MSR is not connected, attach the cover on it.
(Note)Be sure to turn off the SR-600 main power to remove or attach MSR.
6. Base unit connection cable
The dedicated cable to connect SR-600 is attached.
Note:
❏ Bright spot or dark spot can be found on the part of the LCD unit. Also, sometimes
brightness and color are displayed irregularly but these are not the problems of LCD.
❏ Use it within the specification standard. Never use is in the high temperature and humidity,
and avoid the condensation.
If this product is not used within the specification standard, it may result in the shorten its
life, deterioration of display quality, and the damege of the product
.
❏ Do not drop or subject this product to strong impact. It may result in the damage of this
product.
❏ Clean the surface of the touch panel with dry and soft fabric or the fabric with isopropyl
alchol.
❏ Do not touch the touch panel with hard or pointed device.
❏ Do not press the surface of touch panel. It may cause color shading or irrelevant LCD
display.
❏ Do not place or closely contact objects on the LCD monitor. Doing so may result in leaving a
stain on the monitor.
Installing a LCD Unit
Follow the steps below to install the LCD unit.
1. Install the LCD unit on the LCD unit frame by sliding it to the frame.