Epson SR-600 - Manual (Page 60)

3-16 BIOS Setup Rev.A
Confidential
Basic Operation
Starting the device diagnostics utility
To run diagnostics, press the F10 key when you start the system. The message "Diagnostics
program will execute after POST" is displayed, and the device self-diagnostic utility starts up.
Initial screen
When the device diagnostic utility starts, the following screen appears.
3-1 TM port selection
Press left or right arrow to select the port connected to the TM printer, then press enter. The
device diagnostics utility confirms the TM and DM connection and displays their status on the
screen.
The device diagnostics utility displays the option connectivity status and runs the operation test.
Follow these guidelines for using device diagnostics:
Connection to the cash drawer Connects to the cash drawer to test the kick back operation of the drawer.
Connection to the loop back
connector Connects the loop-back connector to the port running test, when
performing a loop-back test to LPT1.
Serial port, LPT port setting It sets to the default setting with BIOS setup utility, when changing the setting
of serial port and LPT1 port.
Table 3-9 Conditions
Setting Condition