Epson SR-600 - Manual (Page 181)

Rev.A Wake On LAN Appendix 3-3
Developer's Guide SR-600 Confidential
Software Setting
BIOS Setting
It is required to set the following items from the BIOS Setup to enables Wake On LAN.
[Wake Up On LAN] from the [POWER MANAGEMENT SETUP].
Disable: Wake On LAN Disabled
Enable: Wake On LAN Enabled
It is possible to activate the Wake Up form the Wake On LAN by setting it to enable. It sets
whether or not the Chipset (A3-2) can receive Wake On LAN signal. It is not for the LAN
Controller setting.
A3-2 Wake On LAN SIgnal Circuit
Note:
BIOS performs this setting to the Chipset while the power is turned off. When the power is on, it is always
set at Disable. Therefore, when the main power switch is pressed for more than 4 seconds and turned it off,
the power is turned off not without going through BIOS and it is set at Disable regardless of its setting.
When it turns into Suspend mode, the resume from the Suspend is always available since BIOS is always
set at Enable.
When the AC power is input (if OI-R03 is not avaiable), Chipset setting is resume to its default setting
and the BIOS setting cannot be reflected. Therefore, the default Wake On LAN is turned on by the
hardware regardless of the BIOS setting.
Wake Up
Signal
Wake On LAN
Signal
Power On
Signal
Power Switch
Signal
LAN
Controller
(RTL8139B)
Chipset
(PIIX4E)
Power
Supply
Unit
SMI