Epson SR-600 - Manual (Page 39)

Rev.A OS and Driver Setup 2-17
Developer's Guide SR-600 Confidential
Video Driver Installation
Follow the steps below to install the Video Driver.
1. Open the control panel and select “Screen”.
2. Set the Driver Disk into FDD.
3. Select “Display Category” from the “Display Setting”.
4. Click on “Change” button and click on “Disk in Use(Have Disk)”.
5. Select Chips Video Accelerator (65545/48/50/54/55 68554 69000) , then type “OK".
Starts the installation.
6. After the installation, reboot the system.
Network Driver Installation
Follow the steps below to install the Network Driver.
1. Open the control panel and select “Network".
2. Set the Driver Disk into FDD.
3. Select “Add” from the “Adapter”.
4. Click on “Disk in Use(Have Disk)”.
5. RTL8139(A/B/C/8130)PCI Fast Ethernet Adapter, then type “OK".
6. Select (1) AUTO for Duplex Mode.
7. After the installation, reboot the system.
OS Master Recovery
Creation of the Recovery Media
CD-ROM for recovery is not included with the system. It is recommended to back up the
recovery following the steps below.
❏ Creation of the startup disk.
1. Start the MS-DOS prompt.
2. Move to C:\backup\recovery\bootfd director.
3. Execute the Makefd.bat file.
4. Insert a floppy disk into the FDD.
5. Press Enter key. (Formatting will start.)