Epson SR-600 - Manual (Page 165)

Rev.A Interfaces Appendix 1-11
Developer's Guide SR-600 Confidential
PCI Slot
The system has one PCI-compliant expansion slot. Any PCI-compliant expansion board can be
used if its outline is not larger than the size shown in the figure below. However, the PCI card
that can be used in the system is in conformity with PCI Version 2.1.
The connector in the PCI-compliant expansion slot is a card edge type.
The dimensions of PCI cards that can be attached are shown below. The maximum card size is
70mm x 105mm. Remove the main cover and under frame to attach or remove the 70mm x
105mm size PCI card. The number in the parentheses indicates the card size that is wearable and
removable from the access point located by the side of SR-600. Be sure to use a PCI card with a
width of 105 mm or less, for safety standard reasons.
A1-12 Outer dimensions of usable PCI-compliant board
105 (95)
170 (145)
<PCI Slot Surface>
unit:mm