Epson SR-600 - Manual (Page 134)

6-28 Peripherals/Option Installation Rev.A
Confidential
❏ Do not use this product in the place where the lots of dusts are found.
❏ If MSR unit is damaged, it may display the keyboard error message when rebooted.
❏ If JIS II type is used in DM-MS112, the setting from the utility is necessary.
Specifications
Installing a MSR Unit
Follow the steps below to install a MSR unit.
1. Connect the connecter on a MSR.
CAUTION:
Connect the brown line of the connecter with no.1 pin in order with the number on the
board.
Connecter may get damaged if the pin is not connected correctly.
2. Connect the connecter on the board of the mSR unit.
Connect with no. 1 pin following the same procedure as step 1.
3. Attach four tabs on the concave portion of the LCD unit to connect with the MSR unit.
Figure 6-6 MSR Unit Specifications
DM-MS123
Compliant
magnetic card ISO7811, JIS x 6301 1type truck 1, 2, and 3
External
Interface LCD Unit (Connected to DM-LS121S and
DM-LS121T)
Compliant
keyboard firm Ver 3.01 or above
Dimensions 46mm(W) x 174mm(D) x 56mm(H)
(Pointed portion not included)
Weight Approximately 270g
Environmental
Specifications Temperature
During operation:5 to 35 Celsius
(41 to 95 Fahrenheit)
During saving:-10 to 50 Celsius
(14 to 122 Fahrenheit)
Humidity
During operation:30 to 80%RH
(no condensation)
During saving:30 to 85%RH
(no condensation)
Reliability Life of magnetic head:300,000
(Magnetic card readable counting time)