Epson SR-600 - Manual (Page 123)

Rev.A Peripherals/Option Installation 6-17
Developer's Guide SR-600 Confidential
Drawer /CRT Board
Specifications
Model name: OI-B08
OI-B08 is a optional board for SR-600. Drawer contol ia available by equipping it to SR-600.
It is mounted a microchip computer and drawer control is operated by interpreting the ESC/
POS code.
When installing this board to the system, select MODE from the BIOS Setup screen. CRT display
function is valid regardless if its MODE.
The connector for CRT is placed on this board, and it provides CRT display function for SR-600.
Select MODE from the BIOS setup screen to enable operation with this board attached.
CAUTION:
Please make sure that the same type of Drawer and CRT Board is used to connect the
Drawer and CRT Board both.
Connect the drawer which use same Drawer Open Status (High/Low).
Set the same transfer rate as DM-D to connect with the DM-D simultaneously.
Figure 6-3 General Specifications
Items Specifications
Drawer Kcikboard
Connector 2 connectors are mounted
(Same as connecting Y cable to the TM Printer drawer connector)
The signal for drawer kickboard is connected to no. 2 pin
Connection drawer 24V 24 Ω or above solenoid is used
CRT connector D-sub 15 pin