KACO Powador 10.0 - 20.0 TL3 - Manual (Page 13)

EN
Mounting the inverter
Operating Instructions Powador 12.0 TL3-20.0 TL3 Page 13
6 Mounting the inverter
DANGER
Risk of fatal injury from fire or explosions
Fire caused by flammable or explosive materials in the vicinity of the inverter can lead to
serious injuries.
› Do not mount the inverter in an area at risk of explosion or in the vicinity of highly flammable
materials.
CAUTION
Risk of burns from hot housing components.
Coming into contact with the housing can cause burns.
› Mount the inverter so that it cannot be touched unintentionally.
Installation space
• As dry as possible, climate-controlled, with the waste heat dissipated away from the inverter.
• Unobstructed air circulation.
• When installing the unit in a control cabinet, provide forced ventilation so that the heat is sufficiently dissipated.
• Close to the ground, accessible from the front and sides without requiring additional resources.
• Protected from direct sunshine outdoors.
• For easy operation, ensure during installation that the display is slightly below eye level.
Wall
• With sufficient load-bearing capacity.
• Accessible for installation and maintenance.
• Made from heat-resistant material (up to 90 °C).
• Flame resistant.
• Minimum clearances to be observed during assembly: see Figure 5 on page 14.
NOTE
Access by maintenance personnel for service
Any additional costs arising from unfavourable structural or mounting conditions shall be billed to
the customer.
CAUTION
The inverter is susceptible to damage by gases that have an abrasive effect on surfaces
in combination.
The inverter housing can be damaged severely by gases (ammoniac, sulfur, etc.) when they
come in contact with ambient humidity caused by the weather.
If the inverter is exposed to gases, it must be mounted so that it can be seen at all times.
› Perform regular visual inspections.
› Immediately remove any moisture from the housing.
› Take care to ensure sufficient ventilation of the inverter.
› Immediately remove dirt, especially on vents.
› Failure to observe these warnings may lead to inverter damage which is not covered by
KACO’s manufacturer warranty.