KACO Powador 10.0 - 20.0 TL3 - Manual (Page 30)

EN EN
Configuration and Operation
Page 30 Operating Instructions Powador 12.0 TL3-20.0 TL3
Authorised electrician
Operating status LEDs Display Description
Feed-in operation Power fed into the grid
or measured values The green “Operating” LED is illuminated.
The green “Feed-in” LED is illuminated.
The “Feed-in” icon appears on the desktop.
The inverter feeds into the grid.
Non-feed-in
operation
Status message The display shows the corresponding
message.
Fault Fault message The display shows the corresponding
message.
The red "Fault" LED is illuminated.
8.1.2 Graphical display
The graphical display shows measured values and data and allows the configuration of the inverter using
a graphical menu. In normal operation, the backlighting is switched off. As soon as you press one of the control
buttons, the backlighting is activated. If no button is pressed for an adjustable period of time, it switches off again.
You can also activate or deactivate the backlighting permanently. In sleep mode, the inverter deactivates the display
regardless of the selected setting.
NOTE
Depending on the tolerances of the measuring elements, the measured and displayed values are
not always the actual values. However, the measuring elements ensure maximum solar yield. Due to
these tolerances, the daily yields shown on the display may deviate from the values on the grid
operator’s feed-in meter by up to 15%.
After being switched on and after initial commissioning is complete, the inverter displays the start screen
(the desktop). If you are in the menu and do not touch the control buttons for two minutes, the inverter returns
to the desktop.
For initial commissioning, see section 8.2 on page 32.
1
2
3
4
5
6
7
8
Figure 17: Desktop
Key
1 Current date 6 Status bar
2 Current power 7 Current time
3 Menu indicator 8 Feed-in indicator
4 Daily yield
5 Annual yield