Epson S5U1C63000A - Manual (Page 201)

CHAPTER 8: DEBUGGER
S5U1C63000A MANUAL EPSON 187
(S1C63 FAMILY ASSEMBLER PACKAGE)
bd
(data break)
Function
This command sets or clears data break. This command allows you to specify the following break
conditions:
1. Memory address range to be read or written (one area)
2. Data pattern to be read or written (bit mask possible)
3. Memory read/write (three conditions: read, write, or read or write)
The program breaks after completing a memory access that satisfies the above conditions.
Format
(1) >bd <data> <option> <address1> <address2>
↵
(direct input mode)
(2) >bd
↵
(guidance mode)
Data break set status
1. set 2. clear …? <1 | 2>
↵
(Command is completed when "2" is selected.)
data Old data : <data>
↵
R/W (R,W,
∗
) Old option : <option>
↵
Start address Old address : <address1>
↵
End address Old address : <address2>
↵
>
<data>: Data pattern; binary (
∗
can be input for the bits to be masked)
<option>: Memory read/write option; r, w, or
∗
<address1–2>: The specified address; hexadecimal or symbol (IEEE-695 format only)
Condition:
0
≤
address1
≤
address2
≤
0xffff, 0
≤
data
≤
0b1111
Examples
Format (1)
>bd 1000 W 0 f
↵
... Sets a data break condition so that the program breaks when 0x8 is written
to the address range from 0x0 to 0xf.
* The direct input mode cannot clear the set condition.
Format (2)
>bd
↵
data: - R/W: - area: -
1. set 2. clear ...? 1
↵
... "1. set" is selected.
data ---- : 1***
↵
... Data pattern is set to 0b1***.
R/W (R,W,*) - : w
↵
... R/W condition is set for write access.
Start address ---- : 0
↵
... Break address range is set to 0x0–0xf.
End address ---- : f
>bd
↵
data: 1*** R/W: W area: 0000 - 000F ... Currently set condition.
1. set 2. clear ...? 2
↵
... "2. clear" is selected.
>bd
↵
data: - R/W: - area: -
1. set 2. clear ...?
↵
...Terminated by [Enter] key.
>
"
∗
" in the binary data pattern specifies that the bit will not be compared with the actual read/write
data.