Epson S5U1C63000A - Manual (Page 273)

CHAPTER 10: SEGMENT OPTION GENERATOR
S5U1C63000A MANUAL EPSON 259
(S1C63 FAMILY ASSEMBLER PACKAGE)
Notes: • The segment assignment data file can be read only when the device information definition file
has been loaded.
• Some models need a function option document file to be loaded at the start of winsog, and the
contents of the file affect the segment option setup condition. Therefore, the segment assign-
ment data file in which the settings do not match the function option cannot be read.
(9) Correcting an existing document file
You can read an existing segment option document file into winsog and correct it as necessary.
To read a file, select [Open] from the [File] menu or click the [Open] button.
[Open] button
The dialog box shown below appears, so enter a file name including the path in the text box or select a
file by clicking the [Ref] button.
Click [OK], and the file is loaded. If the specified file exists and there is no problem with its contents,
[Memory Address/Data bit] and [SEGMENT DECODE TABLE] are updated according to the contents
of the file. To stop loading the file, click [Cancel].
If you want to change an assigned address, clear its cell assignment using the [Delete] button first and
then reassign a new address. If you want to change a selected output mode too, select the correspond-
ing SPEC cell and clear its selected output mode with the [Delete] button before reselecting a new
output mode. Two or more cells selected by dragging an area can also be deleted using the [Delete]
button.
If you select [Generate] without changing the file name, the dialog box asking you whether to over-
write the file is displayed. Click [Yes] to overwrite or [No] or [Cancel] to stop overwriting. Use the
[Setup] dialog box to change the file name.
Notes: • The segment option document file can be read only when the device information definition file
has been loaded.
• Some models need a function option document file to be loaded at the start of winsog, and the
contents of the file affect the segment option setup condition. Therefore, the segment option
document file in which the settings do not match the function option cannot be read.
(10) Quitting
To terminate winsog, select [End] from the [File] menu.