Precision Digital PD6310 - Manual (Page 37)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
37
Display Functions and Messages
The controller displays various functions and messages during setup,
programming, and operation. The following table shows the main menu
functions and messages in the order they appear in the menu.
Display Parameter Action/Setting Description
reset Reset Press Enter to access the Reset menu
Rst Hi Reset high Press Enter to reset max display
Rst Lo Reset low Press Enter to reset min display
Rst HL Reset
high & low Press Enter to reset max & min displays
Rst t Reset total Press Enter to reset total
Rst Gt Reset
grand total Press Enter to reset grand total
Rst bc Reset
batch count Press Enter to reset batch count
Contrl Control Enter Control menu
Auto Automatic Press Enter to set controller for automatic
operation
mAn Manual Press Enter to manually control relays or
analog output operation
setup Setup Enter Setup menu
Input Input Enter Input selection menu
mA 4-20 mA PD6210 Only: Set input for 4-20 mA input
volt 0-10 VDC PD6210 Only: Set input for 10 VDC input
Total Total Enable or disable totalizer features
Dec pt Decimal point Set decimal point for rate, total, grand total
prog Program Enter the Program menu
sCalE Scale Enter the Scale menu
factor K-factor
Scaling PD6310 Only: Programs unit to convert
input pulse to rate in engineering units
Cal Calibrate Enter the Calibrate menu
Inp 1 Input 1 Calibrate input 1 signal or program input 1
value