Precision Digital PD6310 - Manual (Page 39)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
39
Display Parameter Action/Setting Description
Act 1 Action 1 Set relay 1 action 1
Auto Automatic Set relay for automatic reset
A-man Auto-manual 1 Set relay for automatic & manual reset
any time
1
LatCH Latching 1 Set relay for latching operation (relays
assigned to rate)
1
Lt-CLr Latching-
cleared
1
Set relay for latching operation with ma-
nual reset only after alarm condition has
cleared (relays assigned to rate)
1
Altern Alternate
2
Set relay for pump alternation control
(relays assigned to rate)
2
Sampl Sampling Set relay for sampling operation (rate or
GT)
OFF Off Disable relay and front panel status LED
(Select Off to enable Interlock feature)
Set 1 Set 1 Program set point 1
RSt 1 Reset 1 Program reset point 1
RLY 2 Relay 2 Relays 2-8 setup
Note: Relays 5-8 are shown, only if ex-
pansion relay module is installed.
FaiLSF Fail-safe Enter Fail-safe menu
FLS 1 Fail-safe 1 Set relay 1 fail-safe operation
on On Enable fail-safe operation
off Fail-safe off Disable fail-safe operation
DeLAY Delay Enter relay Time Delay menu
DLY 1 Delay 1 Enter relay 1 time delay setup
On 1 On Set relay 1 On time delay
OFF 1 Off Set relay 1 Off time delay
break Loop break Set relay condition if loop break detected
(For mA input only)
iGnorE Ignore Ignore loop break condition
(Processed as a low signal condition)
On On Relay goes to alarm condition when loop
break is detected