Precision Digital PD6310 - Manual (Page 98)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
98
Display Parameter Action/Setting Description
RELaY Relay Enter the Relay menu
reset Reset To access the Reset menu
Right Right arrow Assign digital input to Right arrow button/F1
RLY 1 Relay 1 Relay 1 setup
RLY 2 Relay 2 Relays 2-8 setup
Note: Relays 5-8 are shown, only if expan-
sion relay module is installed.
Rly d Disable relay Assign digital input to disable all relays
Rly E Enable relay Assign digital input to enable all relays
RSt 1 Reset 1 Program reset point 1
Rst bc Reset batch
count To reset the batch count
Rst Gt Reset
grand total To reset grand total
Rst Hi Reset high Press Enter to reset max display
Rst HL Reset
high & low Press Enter to reset max & min displays
Rst Lo Reset low Press Enter to reset min display
Rst t Reset Total Reset total
Sanmpl Sampling Set relay for sampling operation
sCalE Scale Enter the Scale menu
SelEct Select Enter the Select menu (function, cutoff, out)
send Send Send controller settings to another
controller
seriAl Serial Set serial communication parameters
Set 1 Set 1 Program set point 1
setup Setup Enter Setup menu
SlavId Slave ID Set Slave ID or controller address
Source Source Select source for the 4-20 mA output
Square Square root Set controller for square root extraction