Screen brightness, Using eco mode, Power-saving adjustment – Canon EOS M10 User Manual
Page 140
140
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode /
Hybrid Auto Mode
Other Shooting Modes
Tv, Av, and M Mode
Playback Mode
Wi-Fi Functions
Setting Menu
Accessories
Appendix
Index
P Mode
●
To conserve battery power, you should normally choose [On] for
[Auto Power Down] and [1 min.] or less for [Display Off].
●
The [Display Off] setting is applied even if you set [Auto Power
Down] to [Off].
●
These power-saving functions are not available when you have
set Eco mode (= 140) to [On].
Screen Brightness
Adjust screen brightness as follows.
●
Choose [ 2] tab > [LCD Brightness],
press the [ ] button, and then press the
[ ][ ] buttons to adjust the brightness.
●
For maximum brightness, press and hold the [ ] button for at
least one second when the shooting screen is displayed or when
in single-image display. (This will override the [LCD Brightness]
setting on the [ 2] tab.) To restore the original brightness, press
and hold the [ ] button again for at least one second or restart
the camera.
Using Eco Mode
This function allows you to conserve battery power in Shooting mode.
When the camera is not in use, the screen quickly darkens to reduce
battery consumption.
1
Configure the setting.
●
Choose [Eco Mode] on the [ 2] tab, and
then choose [On].
●
[
] is now shown on the shooting
screen (= 167).
●
The screen darkens when the camera
is not used for approximately two
seconds; approximately ten seconds
after darkening, the screen turns off.
The camera turns off after approximately
three minutes of inactivity.
2
Shoot.
●
To activate the screen and prepare for
shooting when the screen is off but the
indicator is lit, press the shutter button
halfway.
Power-Saving Adjustment
Adjust the timing of automatic camera and screen deactivation (Auto
Power Down and Display Off, respectively) as needed (= 29).
●
Choose [Power Saving] on the [ 2] tab,
and then press the [ ] button.
●
Choose an item and press the [ ] button.
Press the [ ][ ] buttons to adjust the
setting, and then press the [ ] button
again.