Inserting flash tube, Inserting halogen lamp for modeling light – Hensel Expert D 1000 Flash Kit User Manual
Page 16
User Manual Expert D 500/1000
16
HENSEL-VISIT GmbH & Co. KG
Â
Then use gentle pressure to insert the safety dome first into
the second spring and then into the third spring until it locks
into place.
Â
Tilt the safety dome slightly so that it is released one by one
from the mounting springs.
Â
Pull the safety dome lightly from the third spring and remo
-
ve it completely.
Note:
Safety domes are available in different types. They can change
the color temperature as well as the light characteristics!
Inserting flash tube
The compact flash unit has a plug-in flash tube, which you can
replace yourself. Please observe the applicable safety precau
-
tions carefully.
Inserting the flash tube is described in the chapter on mainte
-
nance, note „Replacing flash tube“ on page 35.
Inserting halogen lamp for modeling light
The modeling light has a plug-in halogen lamp. Insert the in-
cluded halogen lamp by observing the following instructions:
Note:
Avoid touching the lamp with bare hands since this leaves an
oily residue on the glass surface which reduces the lamp’s ope-
rating life. Use cotton gloves.
Make sure that the flash tube does not become damaged
when inserting it.
Â
Place the pins into the lamp socket and push the lamp care
-
fully into place by alternating the pressure on the pins until
contacting the end stop.
ATTENTION!
Please regard the general safety precautions reference location
and surroundings in the chapter „Set-up and initial operation“
on page 8.
Removal