Setting receiver, Output adjustment, Switching the modeling light – Hensel Expert D 1000 Flash Kit User Manual
Page 25
User Manual Expert D 500/1000
25
HENSEL-VISIT GmbH & Co. KG
Â
Set the channel selection switch
F5
to channel 1, 2 or 3.
- or -
Â
Select the switch position
ALL
when all channels are to be
controlled.
Setting receiver
The key
RC 18
on the flash head is used to activate the radio
receiver and to set the channel.
Â
Briefly press the key
RC 18
until the LED above the key lights
up
green
, or press the digital rotary encoder
16
.
Â
Press the key
RC 18
for ca. 2 s to switch the channels of the
radio receiver.
The display
5
is now blinking and shows the set channel,
e.g. H.C1 for the first channel of
Strobe Wizard Plus.
Â
Turning the rotary encoder
16
within 3 s lets you set the desi
-
red channel.
After the channel „C1“come the channels „C2“and „C3“of Stro
-
be Wizard Plus, directly after them the channels „F1“, „F2“ and
„F3“ of the freemask receiver.
Approximately 3 s after a key was last pressed, the channel is
saved and the display
5
stops blinking.
Output adjustment
The flash output is adjusted in steps of 0.1 f-stops with the two
control keys
q
F1
and
p
F2
on the flash unit.
Â
Briefly press
q
to reduce the output.
Â
Briefly press
p
to increase the output.
The compact flash unit’s LED display shows the selected output
values.
Switching the modeling light
Pressing the
q
key
F1
longer (< 1 sec.) switches on the mode-
ling light of the connected flash head. Depending on the con
-
nected flash head, the modeling light can be set to OFF – FULL
– PROP – OFF.
Selecting radio
channel