Error messages – Hensel Expert D 1000 Flash Kit User Manual
Page 37
User Manual Expert D 500/1000
37
HENSEL-VISIT GmbH & Co. KG
Error messages
In case of an error, an error code is shown in display
5
. In this
case proceed as follows:
Â
Switch off the unit.
Â
Wait a few seconds.
Â
Switch the unit on again.
If the error code persists, check if the problem can be remedied
according to the following list or contact customer service and
state the error code, see „13 Customer service points“ on page
39.
Unit does not flash.
If several units are on the set, the misfiring of individual units is
shown in the display.
Possible causes can be a spent flash tube or an internal equip
-
ment problem.
Â
You may need to replace the flash tube or send the unit in
for service.
This error message disappears on its own after a short period
of time.
Unit is overheated.
In case of this problem, the modeling light shuts off and the
unit stops flashing.
Possible causes can be extensive flashing, high ambient tempe
-
ratures with full modeling light, covered core ducts, unsuitable
reflectors or a defective fan (check by listening).
Â
Keep the unit switched on so that the fan continues to cool
the flash unit.
Remedy or improve the situation by switching off the mode
-
ling light.
The error message disappears once the unit has cooled off.
Error E4
Error E5