8 operation, Switch on/off, Modeling light – Hensel Expert D 1000 Flash Kit User Manual
Page 19
User Manual Expert D 500/1000
19
HENSEL-VISIT GmbH & Co. KG
8 Operation
Switch on/off
The main switch
6
switches the compact flash unit on or off. The
unit is ready to flash as soon as the ready indicator
2
lights up.
ATTENTION!
The power switch must be accessible and operational at all
times.
When turning on the unit, it defaults to the settings used last.
This means the unit „remembers“ the settings at switch-off.
Modeling light
The modeling light is switched on by using the key
PROP 4
or the
key
FULL 17
. An LED above the key indicates the setting.
FULL
: The modeling light is set at full power (300 W).
PROP
: The light output (brightness) of the modeling light is pro-
portional to the flash output.
Automatic modeling light reduction (Autored)
The compact flash unit’s modeling light is equipped with an
energy saving mode. After a preselected time, the light is
automatically reduced to level 9. When set on FULL mode, this
happens regardless of the selected flash output. When set on
PROP mode, this happens when the output setting is between
9.1 and 10. The default is set by the manufacturer at 35 min.
This conserves energy and extends the lamp’s operating life.
The original output is restored when you touch any key.
How to set the switch-off time:
Â
Press the digital rotary encoder
16
twice in fast sequence
(double-click).
The display
5
shows the selected switch-off time for ca. 3 s.,
e.g. A.35
Â
Adjust the time by turning the rotary encoder
16
in 1 minute
increments up to a maximum of 90 minutes.
A setting of „
--
“ causes the function to switch off.