3 safety instructions – Hensel Expert D 1000 Flash Kit User Manual
Page 8
User Manual Expert D 500/1000
8
HENSEL-VISIT GmbH & Co. KG
3 Safety instructions
In addition to the general rules for handling electrical equip
-
ment, the following safety precautions must be observed.
Read and observe the below listed information before initial
operation of the equipment.
Supply a copy of the safety precautions when selling, leasing, or
otherwise distributing this equipment.
ATTENTION!
Improper handling of the device, non-compliance with the safety
hints below, or tampering with the safety features can cause
property damage, bodily injury, electric shock, or even death.
The compact flash unit
Expert D 500/1000
is intended for
professional use inside the studio. It is only to be used with the
accessories described in this manual and approved by Hensel-
Visit.
The equipment may not be used for any other purpose than
described above, especially not for other electrical applications.
Set-up and initial operation
•
Do not use flash units in explosive environments.
•
Before connecting the equipment to the power supply, make
sure that the mains voltage corresponds to the specifications
listed on the unit’s specification plate.
•
Compact flash units and generators must only be connected
to grounded power supply systems.
•
Check the protective conductor function of the power supply
before initial use.
•
Only use plugs/connectors with flawless contacts. Burned or
corroded plug contacts can cause fires. Defective plugs can
cause substantial damage to the plug socket.
•
Do not connect accessories from other manufacturers, even
when these look similar or alike.
Normal use
Abnormal use