Updating software – Hensel Expert D 1000 Flash Kit User Manual
Page 34
User Manual Expert D 500/1000
34
HENSEL-VISIT GmbH & Co. KG
How to replace a fuse:
Â
Open the safety drawer
7
with a small screwdriver and pull
it out.
b
a
Note:
The drawer can only be pulled out approximately 1 cm.
Inside the drawer are two fuses. The rear fuse
a
is an active
fuse, the front fuse
b
is a spare fuse.
Â
Remove the defective fuse
a.
Â
Take out the spare fuse
b
and insert it into the rear holder.
Â
Carefully push the drawer back into the housing until it
locks into place.
Note:
The handle of the compact flash unit contains additional spare
fuses
13
.
Replace spare fuses after removal und insert them into the pro-
per space.
Updating software
If necessary, the compact flash unit’s software can be updated
via the USB interface
21
located on the top side of the housing.
Â
Contact your customer service center, see „13 Customer
service points“ on page 39.
7