Remote trigger – Hensel Expert D 1000 Flash Kit User Manual
Page 30
User Manual Expert D 500/1000
30
HENSEL-VISIT GmbH & Co. KG
Transmitter/receiver mode
Profoto Air Sync/Remote units can either be used as a transmit
-
ter or as a receiver.
Â
Press the
P2 MODE
key until the LED
TRANSMIT
lights up.
This sets up the unit as a transmitter.
- or -
Â
Press the
P2 MODE
key until the LED
RECEIVE
lights up.
This sets up the unit as a receiver.
Remote trigger
The transmitter has 8 different channels for synchronizing flash
heads. The compact flash unit has 8 Profoto Air channels. This
lets you control up to 8 work stations separately.
Channel setting
All units that are supposed to work together need to be set on
the same channel.
The setting is done with the channel selection key
P1
.
Â
Press the channel selection key
P1
until the desired channel
1-8 is indicated on the LED bar.
The Profoto Air channels of
Expert D 500/1000
are desig-
nated with P1- P8 and are shown on display
5
, e.g. P.1A for
channel 1 and group A.
Â
Briefly press the
RC
key
18
several times until the LED above
the key lights up
orange
.
Â
Press the
RC
key
18
for ca. 2 s to change the channels of the
radio receiver or press the digital rotary encoder
16
.
The display
5
is now blinking and shows the set channel,
e.g. P.1A for channel 1 and group A of
Profoto Air
.
Â
Set the desired channel by turning the digital rotary encoder
16
within 3 s.
Channels
Transmitter
Expert D
500/1000