Deactivating the flash adding a date stamp, Ou can also add a date stamp to shots, if you wish, Adding a date stamp – Canon PowerShot ELPH 360 HS Digital Camera (Silver) User Manual
Page 37: Deactivating the flash
37
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode /
Hybrid Auto Mode
Other Shooting Modes
P Mode
Playback Mode
Wi-Fi Functions
Setting Menu
Accessories
Appendix
Index
Adding a Date Stamp
Still Images
Movies
The camera can add the shooting date to images, in the lower-right corner.
However, note that date stamps cannot be edited or removed, so confirm
beforehand that the date and time are correct (
1
Configure the setting.
●
Press the [
] button, choose [Date
Stamp ] on the [ ] tab, and then
choose the desired option (
●
Once the setting is complete, [ ] is
displayed.
2
Shoot.
●
As you take shots, the camera adds the
shooting date or time to the lower-right
corner of images.
●
To restore the original setting, choose
[Off] in step 1.
●
Date stamps cannot be edited or removed.
●
Shots taken without adding a date stamp can be printed with one
as follows.
However, adding a date stamp this way to images that already
have one may cause it to be printed twice.
-
Print using printer functions (
-
Use camera DPOF print settings (
●
For movies recorded using the self-timer, recording begins after
your specified delay time, but specifying the number of shots has
no effect.
●
When you specify multiple shots, image brightness and white
balance are determined by the first shot. More time is required
between shots when the flash fires or when you have specified
to take many shots. Shooting will stop automatically when the
memory card becomes full.
●
When a delay longer than two seconds is specified, two seconds
before the shot, the lamp blinking and self-timer sound will speed
up. (The lamp will remain lit in case the flash fires.)
Deactivating the Flash
Still Images
Movies
Prepare the camera for shooting without the flash as follows.
●
Press the [ ] button several times until
[ ] is displayed.
●
The flash will no longer be activated.
●
To activate the flash, press the [ ] button
again. ([ ] is displayed.) The flash will
automatically fire in low-light conditions.
●
If a blinking [ ] icon is displayed when you press the shutter button
halfway in camera-shake inducing, low-light conditions, mount the
camera on a tripod or take other measures to keep it still.